Results

Each study below carries the full job record: service, scope, parts, size, price, time on site, the problem found, and what the owner said at the end.

📞 Talk to an HVAC Specialist: (983) 900-5808

Frequently Asked Questions

How much does a furnace repair cost?

Most furnace repairs run $189 to $780. Igniters, sensors, and switches land in the low hundreds. Blower motors and boards cost more. The price is set in writing at the visit, before work starts.

How much does a new furnace cost in Highlands Ranch?

Most installs run $4,800 to $8,500 for one system. The vent plan and the efficiency class move the price most. The permit and haul-away are in the price.

How much does a new AC cost?

Most installs run $5,200 to $9,800 for one system. Size, efficiency, and duct state move the price. A load check sets the size; we never size from the old unit's label.

Why does altitude matter for a furnace?

At 5,900 feet the air holds less oxygen. Gas pressure and combustion air must be set for thin air. A sea-level setup soots, locks out on cold nights, and can be a safety risk.

What is the $5,000 rule?

Multiply the age of the system by the repair quote. If the result passes $5,000, a swap is worth a hard look. We show both prices so you can run the math yourself.

Do heat pumps work in Colorado cold?

Cold-climate models hold heat down to the cold snaps we get a few nights a year. A dual-fuel plan keeps a gas furnace for those nights. We show the cost math in the open.

What Does My HVAC Project Cost?

HVAC work is priced per job or per system — repairs by the part that failed, installs by the system and its efficiency tier. Here are the ranges we see on real jobs around Highlands Ranch, and a calculator built on the same numbers.

Furnace & AC Repair

Most repairs land $189 to $780. Wear parts — igniters, sensors, capacitors, contactors — run $189 to $400; a blower motor or control board runs $400 to $780; a heat pump repair runs $220 to $850. The diagnostic is in every range here, and you get one price in writing before work starts.

Furnace Installation

A standard 80% AFUE furnace runs $4,800 to $6,500 installed; a 96% condensing furnace runs $6,500 to $8,500, PVC vent rework included. Every install is sized by a load check and set up for 5,900 feet — permit and haul-away are in the price.

AC Installation & Replacement

A standard 14–15 SEER2 system runs $5,200 to $7,900; a high-efficiency variable-speed system runs $7,500 to $9,800. Sized to your house and your ducts by a load check — never from the old unit's label.

Heat Pump Installation

A ducted heat pump runs $7,500 to $11,000; a cold-climate dual-fuel system — pump plus your gas furnace as backup — runs $9,500 to $14,000. The change-over point is set with you, and rebate lines are shown apart from the price on the quote.

Ductless Mini-Splits

A single-zone system for one problem room runs $3,800 to $6,500; a multi-zone system for two to four rooms runs $6,500 to $12,000. No ducts to run, and each room gets its own setting.

Maintenance & Tune-Ups

A seasonal tune-up runs $129 to $189 a system: sensors, start parts, coils, drains, and gas safety checked before they fail at the worst time. A weak part found in fall costs a fraction of the same part on the coldest night of the year.

What Moves the Price

  • Efficiency tier. A 96% condensing furnace or an 18+ SEER2 AC costs more up front than the standard tier — the vent rework, the second heat exchanger, and the variable-speed motor are real hardware. The written quote shows both tiers side by side.
  • The $5,000 rule. Multiply the age of your system by the repair quote. If the result passes $5,000, a swap is worth a hard look. We show both prices — repair and replacement — so you can run the math yourself.
  • Altitude. At 5,900 feet the air holds less oxygen. Gas pressure and combustion air are set for thin air on every install and checked on every furnace tune-up. A sea-level setup soots and locks out on cold nights.
  • Duct state. Leaky or undersized ducts waste a new system's output. Ducts are checked on the site visit; sealing at the plenum is small work, a full duct run is its own line on the quote — never folded into the system price.

These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.

A note on sizing. Every install here is figured off a load check on your house — square feet, windows, ducts, and our 5,900-foot altitude — not off the old unit's label. An oversized system short-cycles; an undersized one never catches up on the coldest night. The load check is part of the site visit, before any price is set.

Estimate Your Project

1 · Pick your project

Emergency calls — no heat in a cold snap, no cool in a heat wave — price off this same panel. The price is set in writing at the visit, before work starts.

Free — no obligation. Your calculator numbers ride along with the request.

Technician's hands at the open panel of an outdoor condenser, checking copper refrigerant lines

Case study 1 — Furnace Installation in Highlands Ranch — Indigo Hill

An Indigo Hill two-story had a loud, short-running furnace and cold upstairs rooms. The load check sized a 96% unit, the vent was reworked in PVC, and gas pressure was set for altitude.

Service performed
Furnace Installation.
Scope of work
Pull the permit, swap a 22-year-old furnace for a 96% unit, rework the vent, and set gas pressure for altitude.
Materials / products used
96% AFUE gas furnace, PVC vent kit, new filter rack.
Size
One system for a two-story home, about 2,400 sq ft.
Final price
$7,450.
Cost per sq ft
Not applicable — HVAC work is priced per job or per system, not per sq ft.
Turnaround / duration
1 day on site, after the home check.
Payment terms / financing
Half at booking, half at the walkthrough.
Problem found
Old furnace short-cycled and had a cracked inducer housing.
Solution delivered
New high-efficiency furnace set, vented, and tuned for 5,900 feet. Ducts sealed at the plenum.
Homeowner first name
Dana.
Homeowner city / neighborhood
Highlands Ranch — Indigo Hill.
Homeowner situation (in their own terms)
Our old furnace ran loud and the upstairs never warmed up.
Outcome and homeowner reaction
The upstairs gap closed to one degree. Dana kept the quote sheet: 'Each line was clear, and the final bill matched it to the dollar.'

Case study 2 — AC Installation and Replacement in Highlands Ranch — Eastridge

An Eastridge home had an R-22 system with a dead compressor. A load check sized the new unit, ducts were checked for leaks first, and the swap took one day.

Service performed
AC Installation and Replacement.
Scope of work
Load check, swap a 19-year-old unit and coil, set the new unit level, charge by weight and test.
Materials / products used
3.5-ton AC unit and coil, new pad, line set flush.
Size
One system for a two-story home, about 2,600 sq ft.
Final price
$8,150.
Cost per sq ft
Not applicable — HVAC work is priced per job or per system, not per sq ft.
Turnaround / duration
1 day on site, permit pulled before.
Payment terms / financing
Half at booking, half at the walkthrough.
Problem found
R-22 unit with a failed compressor and a leaking coil.
Solution delivered
New unit sized by load check, set level, charged, and tested in each room. Old unit hauled away.
Homeowner first name
Tom.
Homeowner city / neighborhood
Highlands Ranch — Eastridge.
Homeowner situation (in their own terms)
The old unit used the gas they do not make now, and each summer the repairs got bigger.
Outcome and homeowner reaction
The house held 72 on a 95-degree day. Tom said the load check is what he tells friends about: 'They sized it to the house, not to the old box.'

Case study 3 — Heat Pump Installation and Repair in Highlands Ranch — Northridge

A Northridge home swapped an aging AC for a cold-climate heat pump and kept its gas furnace as backup. The quote showed the rebate lines apart from the price.

Service performed
Heat Pump Installation and Repair.
Scope of work
Fit a cold-climate heat pump with the gas furnace kept as backup. Set the change-over point with the owner.
Materials / products used
Cold-climate heat pump, new coil, dual-fuel control kit.
Size
One dual-fuel system for a home of about 2,200 sq ft.
Final price
$11,900.
Cost per sq ft
Not applicable — HVAC work is priced per job or per system, not per sq ft.
Turnaround / duration
2 days on site.
Payment terms / financing
Half at booking, half at the walkthrough. Rebate lines shown apart in the quote.
Problem found
Aging AC plus a wish to cut gas use without losing cold-night heat.
Solution delivered
Heat pump heats and cools. The furnace takes over only on the coldest nights, by the setting the owner picked.
Homeowner first name
Ellen.
Homeowner city / neighborhood
Highlands Ranch — Northridge.
Homeowner situation (in their own terms)
I wanted off gas for most of the year but I did not trust a pump alone at ten below.
Outcome and homeowner reaction
The pump carried the house through the fall. Ellen said the open cost math 'was the first quote that showed me the weak points too.'

Case study 4 — Ductless Mini-Split Installation in Parker

A Parker primary suite baked every afternoon while the rest of the house held temperature. A single-zone mini-split went in without new ductwork.

Service performed
Ductless Mini-Split Installation.
Scope of work
Fit a single-zone mini-split in a south-facing primary suite: outdoor unit on a pad, one wall head, line set through the wall, charged and tested.
Materials / products used
Single-zone mini-split, wall head, pad, line set.
Size
One zone for a primary suite of about 400 sq ft.
Final price
$4,900.
Cost per sq ft
Not applicable — HVAC work is priced per job or per system, not per sq ft.
Turnaround / duration
1 day on site.
Payment terms / financing
Half at booking, half at the walkthrough.
Problem found
Suite overheated every afternoon while the rest of the house held temp.
Solution delivered
One ductless head on its own setting. The suite holds its temperature and the main system rests.
Homeowner first name
Rob and Lisa.
Homeowner city / neighborhood
Parker.
Homeowner situation (in their own terms)
The suite baked every afternoon and we did not want ducts torn through the attic.
Outcome and homeowner reaction
The room holds its temperature now. Rob said the quiet is the part he notices most: 'You hear the air, not the machine.'

Case study 5 — Furnace Repair in Littleton

A Littleton furnace ran, blew cold, and shut off. The start chain was tested in order and the amp draw pointed at the blower motor.

Service performed
Furnace Repair.
Scope of work
Test the full start chain in order, fit a new blower motor, and re-test airflow room by room.
Materials / products used
Blower motor.
Size
One system for a two-story home.
Final price
$560.
Cost per sq ft
Not applicable — HVAC work is priced per job or per system, not per sq ft.
Turnaround / duration
Same day, about 2 hours on site.
Payment terms / financing
Paid at the visit. The price was set in writing before work started.
Problem found
Blower motor worn and drawing high amps. The furnace blew cold and shut off.
Solution delivered
New motor fitted and airflow re-tested in each room. Heat was back the same visit.
Homeowner first name
Steve.
Homeowner city / neighborhood
Littleton.
Homeowner situation (in their own terms)
The furnace ran, blew cold, and shut off.
Outcome and homeowner reaction
Heat was back the same visit. Steve kept the test sheet: 'They showed me the amp draw before they sold me anything.'

Case study 6 — Air Conditioning Repair in Castle Rock

A Castle Rock AC hummed and would not start on the hottest Saturday of the summer. The start-chain test found two failed wear parts, both on the truck.

Service performed
Air Conditioning Repair.
Scope of work
Test the start chain, fit a new capacitor and contactor from truck stock, and run a full cooling cycle with the owners there.
Materials / products used
Capacitor, contactor.
Size
One system for a single-story home.
Final price
$340.
Cost per sq ft
Not applicable — HVAC work is priced per job or per system, not per sq ft.
Turnaround / duration
Same day, about 1 hour on site.
Payment terms / financing
Paid at the visit. The price was set in writing before work started.
Problem found
Failed capacitor and a pitted contactor. The unit hummed and would not start.
Solution delivered
Both wear parts fitted. The system started on the first try and held temp all weekend.
Homeowner first name
Paul and Jen.
Homeowner city / neighborhood
Castle Rock.
Homeowner situation (in their own terms)
The unit hummed and would not start on the hottest Saturday of the summer.
Outcome and homeowner reaction
It held temp all weekend. Jen said the written price came first: 'One price, in writing, before a single part went in.'

Book Step One: The Site Visit

Call 983-900-5808 or send the form. Pick your window in the form. The office calls the day before your visit to confirm.

Each job is logged step by step, from first call to final walkthrough. You get the written price before work starts.

Book a Site Visit

Pick your window here, or use the picker on the home page and it lands here for you. The office calls the day before to confirm.

📞 (983) 900-5808