Ductless Mini-Split Installation in Highlands Ranch, CO
Some rooms refuse to stay in line on the main system: the bonus room over the garage, the south-facing suite, the finished basement that runs ten degrees off. A ductless mini-split fixes that one room: a quiet wall unit, a small outdoor unit, and a line set between them. Single-zone systems run $3,800 to $6,500 and go in over one day. No ducts are run, and no other room is touched.
📞 Talk to an HVAC Specialist: (983) 900-5808Frequently Asked Questions — questions about mini-splits
How much does a mini-split cost in Highlands Ranch?
Single-zone systems run $3,800 to $6,500. Multi-zone homes run $6,500 to $12,000. One price per zone plan, in writing.
How long does an install take?
One day for a single zone. Multi-zone homes can take two days. The room is in service the same day the crew leaves.
Can a mini-split heat in a Colorado winter?
Cold-climate models hold heat through the cold snaps we see here. For a whole-home swap we talk through backup heat; for one room, the unit stands on its own.
Will it be loud?
Indoor units run at a whisper — softer than a fridge hum. The outdoor unit is a small fan unit, set away from bedroom glass where the lot allows.
Do mini-splits need ducts or big wall work?
No ducts. The wall work is one small line hole per zone. That is the whole footprint.
Are there rebates?
Qualifying cold-climate gear can earn Xcel and state rebates. The quote flags the lines so the claim starts with the job.
What Does My HVAC Project Cost?
HVAC work is priced per job or per system — repairs by the part that failed, installs by the system and its efficiency tier. Here are the ranges we see on real jobs around Highlands Ranch, and a calculator built on the same numbers.
Furnace & AC Repair
Most repairs land $189 to $780. Wear parts — igniters, sensors, capacitors, contactors — run $189 to $400; a blower motor or control board runs $400 to $780; a heat pump repair runs $220 to $850. The diagnostic is in every range here, and you get one price in writing before work starts.
Furnace Installation
A standard 80% AFUE furnace runs $4,800 to $6,500 installed; a 96% condensing furnace runs $6,500 to $8,500, PVC vent rework included. Every install is sized by a load check and set up for 5,900 feet — permit and haul-away are in the price.
AC Installation & Replacement
A standard 14–15 SEER2 system runs $5,200 to $7,900; a high-efficiency variable-speed system runs $7,500 to $9,800. Sized to your house and your ducts by a load check — never from the old unit's label.
Heat Pump Installation
A ducted heat pump runs $7,500 to $11,000; a cold-climate dual-fuel system — pump plus your gas furnace as backup — runs $9,500 to $14,000. The change-over point is set with you, and rebate lines are shown apart from the price on the quote.
Ductless Mini-Splits
A single-zone system for one problem room runs $3,800 to $6,500; a multi-zone system for two to four rooms runs $6,500 to $12,000. No ducts to run, and each room gets its own setting.
Maintenance & Tune-Ups
A seasonal tune-up runs $129 to $189 a system: sensors, start parts, coils, drains, and gas safety checked before they fail at the worst time. A weak part found in fall costs a fraction of the same part on the coldest night of the year.
What Moves the Price
- Efficiency tier. A 96% condensing furnace or an 18+ SEER2 AC costs more up front than the standard tier — the vent rework, the second heat exchanger, and the variable-speed motor are real hardware. The written quote shows both tiers side by side.
- The $5,000 rule. Multiply the age of your system by the repair quote. If the result passes $5,000, a swap is worth a hard look. We show both prices — repair and replacement — so you can run the math yourself.
- Altitude. At 5,900 feet the air holds less oxygen. Gas pressure and combustion air are set for thin air on every install and checked on every furnace tune-up. A sea-level setup soots and locks out on cold nights.
- Duct state. Leaky or undersized ducts waste a new system's output. Ducts are checked on the site visit; sealing at the plenum is small work, a full duct run is its own line on the quote — never folded into the system price.
These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.
A note on sizing. Every install here is figured off a load check on your house — square feet, windows, ducts, and our 5,900-foot altitude — not off the old unit's label. An oversized system short-cycles; an undersized one never catches up on the coldest night. The load check is part of the site visit, before any price is set.
Estimate Your Project
Emergency calls — no heat in a cold snap, no cool in a heat wave — price off this same panel. The price is set in writing at the visit, before work starts.
Permit, haul-away, and the altitude setup are in every price. Vent rework in PVC is in the 96% tier.
New pad, line-set flush, charge by weight, and a room-by-room test are in every price.
Rebate lines are shown apart from the price on your written quote — never netted into these ranges.
One quiet wall unit per room, each with its own setting. Most single-zone jobs run one day.
Sensors, start parts, coils, drains, and gas safety — the parts that fail most, checked before they fail.
Free — no obligation. Your calculator numbers ride along with the request.
Send Your Project to Highlands Ranch HVAC Pros
Your estimate is attached automatically. Add your info and — if you can — a few photos of the project. Photos help us price the job before we ever set foot in the house. Prefer to talk? Call (983) 900-5808.

One job, step by step
A Westridge bonus room over the garage ran ten degrees off in both seasons. A single-zone mini-split went in over one day: wall unit up, line set run, outdoor unit set on a pad. The room was tested in heat and in cool mode.
- Service performed
- Ductless Mini-Split Installation.
- Scope of work
- Fit one wall unit in a bonus room over the garage, run the line set, and set the outdoor unit on a pad.
- Materials / products used
- Single-zone cold-climate mini-split, line set, pad.
- Size
- One zone, room of about 420 sq ft.
- Final price
- $4,650.
- Cost per sq ft
- Not applicable — HVAC work is priced per job or per system, not per sq ft.
- Turnaround / duration
- 1 day on site.
- Payment terms / financing
- Half at booking, half at the walkthrough.
- Problem found
- Bonus room ran ten degrees off the rest of the house in both seasons.
- Solution delivered
- A single-zone unit now holds the room within one degree, with its own stat.
- Homeowner first name
- Chris.
- Homeowner city / neighborhood
- Highlands Ranch — Westridge.
- Homeowner situation (in their own terms)
- The bonus room was a sauna in July and a fridge in January. We did not want ducts torn through the house for one room.
- Outcome and homeowner reaction
- The room now holds its own temp year-round. Chris uses it as an office: 'It is the first fix that solved the room and left the rest of the house alone.'
How a mini-split install runs
- 1
Call and room check
10 minutes
Tell us the room that will not stay in line: the bonus room, the suite, or the basement. One photo of the room and one of the wall help a lot.
- 2
Site visit and zone plan
30 to 45 minutes
We check wall spots, the line path, and the outdoor pad spot. You get one price per zone plan, in writing, with the heat rating stated plain.
- 3
Book the day
2 minutes
You pick the day and the window. Most single-zone jobs need one day. The office calls the day before to confirm.
- 4
Install day
4 to 8 hours
The wall unit goes up, a small line hole is drilled, and the outdoor unit is set. Lines are run neat, charged, and tested the same day.
- 5
Room check and sign-off
20 minutes
The room is run in heat and in cool mode. You get the remote walk-through and the app setup. The bill matches the written price.
Heat, too
Mini-splits are heat pumps. The unit that cools the room in July heats it in January. Cold-climate models keep working through Colorado cold. Each zone gets its own stat, so you stop paying to condition rooms no one uses.
Where mini-splits win
- Bonus rooms and rooms over garages
- Garage conversions, sunrooms, and basement finishes
- Suite additions that the main ducts never reached
- Homes with boiler heat and no ducts, where central air means a full duct build
- Multi-zone plans for additions and smaller whole homes
What the install holds
The install covers the full zone plan: wall unit mounted and leveled, line set run and insulated, outdoor unit set and wired, and the charge set for the line length. Indoor units run at a whisper, with remote and app control. The room is tested in heat and in cool mode before sign-off.
Book Step One: The Site Visit
Call 983-900-5808 or send the form. Pick your window in the form. The office calls the day before your visit to confirm.
Each job is logged step by step, from first call to final walkthrough. You get the written price before work starts.
Book a Site Visit
Pick your window here, or use the picker on the home page and it lands here for you. The office calls the day before to confirm.
Related services: HVAC Maintenance and Tune-Ups, Emergency HVAC Repair, and Furnace Repair.
Also serving: HVAC Services in Parker, HVAC Services in Lone Tree, and HVAC Services in Englewood.
Related Services
AC Installation · AC Repair · Emergency HVAC Repair · Furnace Installation · Furnace Repair · Heat Pump Installation and Repair · HVAC Maintenance and Tune-Ups · HVAC Replacement · Thermostat Installation & Replacement · Indoor Air Quality Services · Air Duct Cleaning · Air Duct Repair & Replacement · Whole-Home Humidifiers · Ductless Mini-Split Repair