Furnace Installation in Highlands Ranch, CO

A new furnace is a 15-to-20-year call, and the install day matters more than the brand on the box. Most installs in Highlands Ranch run $4,800 to $8,500 for one system and take one day on site. We size from a load check of your house — rooms, glass, insulation, and duct state — never from the old unit's size.

📞 Talk to an HVAC Specialist: (983) 900-5808

Frequently Asked Questions — questions about furnace installation

How much does a new furnace cost in Highlands Ranch?

Most installs run $4,800 to $8,500 for one system. The efficiency class and the vent plan move the price most. Permit and haul-away are in the price.

How long does an install take?

One day for most homes. The new unit is set, vented, tuned for altitude, and run through full heat cycles before we leave.

80% or 96% — which should I pick?

An 80% unit costs less up front and uses the old flue. A 96% unit burns less gas but needs a vent and drain plan. We price both for your home and show the gas math.

Do I need a permit for a furnace swap?

Yes. A permit and an inspection are part of the job. The fee shows at cost on the quote.

Will a new furnace fix my cold upstairs?

If the ducts leak or the size was wrong, yes, it can. The load check and the duct check come first, so the new unit is not blamed for an old duct fault.

What happens to the old furnace?

It comes out and is hauled away the same day. That line is in the written price.

What Does My HVAC Project Cost?

HVAC work is priced per job or per system — repairs by the part that failed, installs by the system and its efficiency tier. Here are the ranges we see on real jobs around Highlands Ranch, and a calculator built on the same numbers.

Furnace & AC Repair

Most repairs land $189 to $780. Wear parts — igniters, sensors, capacitors, contactors — run $189 to $400; a blower motor or control board runs $400 to $780; a heat pump repair runs $220 to $850. The diagnostic is in every range here, and you get one price in writing before work starts.

Furnace Installation

A standard 80% AFUE furnace runs $4,800 to $6,500 installed; a 96% condensing furnace runs $6,500 to $8,500, PVC vent rework included. Every install is sized by a load check and set up for 5,900 feet — permit and haul-away are in the price.

AC Installation & Replacement

A standard 14–15 SEER2 system runs $5,200 to $7,900; a high-efficiency variable-speed system runs $7,500 to $9,800. Sized to your house and your ducts by a load check — never from the old unit's label.

Heat Pump Installation

A ducted heat pump runs $7,500 to $11,000; a cold-climate dual-fuel system — pump plus your gas furnace as backup — runs $9,500 to $14,000. The change-over point is set with you, and rebate lines are shown apart from the price on the quote.

Ductless Mini-Splits

A single-zone system for one problem room runs $3,800 to $6,500; a multi-zone system for two to four rooms runs $6,500 to $12,000. No ducts to run, and each room gets its own setting.

Maintenance & Tune-Ups

A seasonal tune-up runs $129 to $189 a system: sensors, start parts, coils, drains, and gas safety checked before they fail at the worst time. A weak part found in fall costs a fraction of the same part on the coldest night of the year.

What Moves the Price

  • Efficiency tier. A 96% condensing furnace or an 18+ SEER2 AC costs more up front than the standard tier — the vent rework, the second heat exchanger, and the variable-speed motor are real hardware. The written quote shows both tiers side by side.
  • The $5,000 rule. Multiply the age of your system by the repair quote. If the result passes $5,000, a swap is worth a hard look. We show both prices — repair and replacement — so you can run the math yourself.
  • Altitude. At 5,900 feet the air holds less oxygen. Gas pressure and combustion air are set for thin air on every install and checked on every furnace tune-up. A sea-level setup soots and locks out on cold nights.
  • Duct state. Leaky or undersized ducts waste a new system's output. Ducts are checked on the site visit; sealing at the plenum is small work, a full duct run is its own line on the quote — never folded into the system price.

These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.

A note on sizing. Every install here is figured off a load check on your house — square feet, windows, ducts, and our 5,900-foot altitude — not off the old unit's label. An oversized system short-cycles; an undersized one never catches up on the coldest night. The load check is part of the site visit, before any price is set.

Estimate Your Project

1 · Pick your project

Emergency calls — no heat in a cold snap, no cool in a heat wave — price off this same panel. The price is set in writing at the visit, before work starts.

Free — no obligation. Your calculator numbers ride along with the request.

Technician's hands driving ductwork screws during a furnace installation in Highlands Ranch, CO

One job, step by step

An Indigo Hill two-story had a loud, short-running furnace and cold upstairs rooms. The load check sized a 96% unit, the vent was reworked in PVC, and gas pressure was set for altitude. Room temps were checked one by one at the walkthrough.

Service performed
Furnace Installation.
Scope of work
Pull the permit, swap a 22-year-old furnace for a 96% unit, rework the vent, and set gas pressure for altitude.
Materials / products used
96% AFUE gas furnace, PVC vent kit, new filter rack.
Size
One system for a two-story home, about 2,400 sq ft.
Final price
$7,450.
Cost per sq ft
Not applicable — HVAC work is priced per job or per system, not per sq ft.
Turnaround / duration
1 day on site, after the home check.
Payment terms / financing
Half at booking, half at the walkthrough.
Problem found
Old furnace short-cycled and had a cracked inducer housing.
Solution delivered
New high-efficiency furnace set, vented, and tuned for 5,900 feet. Ducts sealed at the plenum.
Homeowner first name
Dana.
Homeowner city / neighborhood
Highlands Ranch — Indigo Hill.
Homeowner situation (in their own terms)
Our old furnace ran loud and the upstairs never warmed up. We wanted the math on 80% versus 96% in plain words before we chose.
Outcome and homeowner reaction
The upstairs gap closed to one degree. Dana kept the quote sheet: 'Each line was clear, and the final bill matched it to the dollar.'

How a furnace install runs

Call and home check

10 minutes

Tell us the age of the old furnace and what it does wrong. We book a home visit to size the new one. No size is picked from the old unit's label.

Load check and options

About 1 hour

We measure the house: rooms, glass, and duct state. You get two or three furnace picks with the vent plan for each, and one price per pick, in writing.

Permit and book the day

1 to 3 days

The Douglas County permit is pulled as part of the job. You pick the install day and the window. The office calls the day before to confirm.

Install day

1 day

Floors are covered. The old furnace comes out and is hauled away. The new unit is set, vented, and piped, with gas pressure set for 5,900 feet.

Test and walkthrough

About 1 hour

The system runs through full heat cycles. Air is checked room by room. You learn the filter size and the stat, and the inspection is booked.

Set up for 5,900 feet

A furnace here must be set for thin air: gas pressure and combustion checked for altitude, and venting matched to its class. An 80% unit vents through the old metal flue. A 96% unit vents in plastic pipe and needs a drain. We walk both plans in your home and price each one in the open.

What the price holds

Signs it is time to swap

Book Step One: The Site Visit

Call 983-900-5808 or send the form. Pick your window in the form. The office calls the day before your visit to confirm.

Each job is logged step by step, from first call to final walkthrough. You get the written price before work starts.

Book a Site Visit

Pick your window here, or use the picker on the home page and it lands here for you. The office calls the day before to confirm.

Related services: Furnace Repair, Air Conditioning Repair, and AC Installation and Replacement.

Also serving: HVAC Services in Parker, HVAC Services in Lone Tree, and HVAC Services in Englewood.

📞 (983) 900-5808