Heat Pump Installation and Repair in Highlands Ranch, CO
Heat pumps used to be a hard sell in Colorado. Cold-climate models changed that: they hold heat down to the cold snaps we see a few nights a year, and they cool in summer with less power than most air conditioners. Repairs run $220 to $850. New cold-climate systems run $7,500 to $14,000, with rebate lines shown apart in the quote.
📞 Talk to an HVAC Specialist: (983) 900-5808Frequently Asked Questions — questions about heat pumps
Do heat pumps work at 5,900 feet in real cold?
Cold-climate models hold most of their heat output down to the cold snaps we get a few nights a year. Below that, backup heat — strips or a gas furnace — carries the house.
How much does a heat pump cost in Highlands Ranch?
New systems run $7,500 to $14,000 for one home system. Repairs run $220 to $850. Rebate lines are shown apart in the quote, so the net cost is plain.
Is a heat pump cheaper to run than a gas furnace?
At current rates, heat can cost a bit more per month than a new 96% furnace. Cool season costs less. We run your bills through the math before you choose.
What is dual fuel?
A heat pump plus a gas furnace. The pump does most of the year; the furnace takes the coldest nights. One stat runs both, at a change-over point set with you.
My pump ices up and stays iced. What is wrong?
A failed defrost board or a low charge can each do it. Both are tested at the first visit, and the fix is priced in writing.
Do rebates apply here?
Xcel and state programs pay on qualifying cold-climate gear. The quote flags the rebate lines so the paperwork starts with the job, not after it.
What Does My HVAC Project Cost?
HVAC work is priced per job or per system — repairs by the part that failed, installs by the system and its efficiency tier. Here are the ranges we see on real jobs around Highlands Ranch, and a calculator built on the same numbers.
Furnace & AC Repair
Most repairs land $189 to $780. Wear parts — igniters, sensors, capacitors, contactors — run $189 to $400; a blower motor or control board runs $400 to $780; a heat pump repair runs $220 to $850. The diagnostic is in every range here, and you get one price in writing before work starts.
Furnace Installation
A standard 80% AFUE furnace runs $4,800 to $6,500 installed; a 96% condensing furnace runs $6,500 to $8,500, PVC vent rework included. Every install is sized by a load check and set up for 5,900 feet — permit and haul-away are in the price.
AC Installation & Replacement
A standard 14–15 SEER2 system runs $5,200 to $7,900; a high-efficiency variable-speed system runs $7,500 to $9,800. Sized to your house and your ducts by a load check — never from the old unit's label.
Heat Pump Installation
A ducted heat pump runs $7,500 to $11,000; a cold-climate dual-fuel system — pump plus your gas furnace as backup — runs $9,500 to $14,000. The change-over point is set with you, and rebate lines are shown apart from the price on the quote.
Ductless Mini-Splits
A single-zone system for one problem room runs $3,800 to $6,500; a multi-zone system for two to four rooms runs $6,500 to $12,000. No ducts to run, and each room gets its own setting.
Maintenance & Tune-Ups
A seasonal tune-up runs $129 to $189 a system: sensors, start parts, coils, drains, and gas safety checked before they fail at the worst time. A weak part found in fall costs a fraction of the same part on the coldest night of the year.
What Moves the Price
- Efficiency tier. A 96% condensing furnace or an 18+ SEER2 AC costs more up front than the standard tier — the vent rework, the second heat exchanger, and the variable-speed motor are real hardware. The written quote shows both tiers side by side.
- The $5,000 rule. Multiply the age of your system by the repair quote. If the result passes $5,000, a swap is worth a hard look. We show both prices — repair and replacement — so you can run the math yourself.
- Altitude. At 5,900 feet the air holds less oxygen. Gas pressure and combustion air are set for thin air on every install and checked on every furnace tune-up. A sea-level setup soots and locks out on cold nights.
- Duct state. Leaky or undersized ducts waste a new system's output. Ducts are checked on the site visit; sealing at the plenum is small work, a full duct run is its own line on the quote — never folded into the system price.
These are planning ranges, not a quote — your final price is confirmed after an in-person look, before any work starts.
A note on sizing. Every install here is figured off a load check on your house — square feet, windows, ducts, and our 5,900-foot altitude — not off the old unit's label. An oversized system short-cycles; an undersized one never catches up on the coldest night. The load check is part of the site visit, before any price is set.
Estimate Your Project
Emergency calls — no heat in a cold snap, no cool in a heat wave — price off this same panel. The price is set in writing at the visit, before work starts.
Permit, haul-away, and the altitude setup are in every price. Vent rework in PVC is in the 96% tier.
New pad, line-set flush, charge by weight, and a room-by-room test are in every price.
Rebate lines are shown apart from the price on your written quote — never netted into these ranges.
One quiet wall unit per room, each with its own setting. Most single-zone jobs run one day.
Sensors, start parts, coils, drains, and gas safety — the parts that fail most, checked before they fail.
Free — no obligation. Your calculator numbers ride along with the request.
Send Your Project to Highlands Ranch HVAC Pros
Your estimate is attached automatically. Add your info and — if you can — a few photos of the project. Photos help us price the job before we ever set foot in the house. Prefer to talk? Call (983) 900-5808.

One job, step by step
A Northridge home swapped an aging AC for a cold-climate heat pump and kept its gas furnace as backup. The quote showed the rebate lines apart from the price. Change-over was set at the walkthrough, with the owner at the stat.
- Service performed
- Heat Pump Installation and Repair.
- Scope of work
- Fit a cold-climate heat pump with the gas furnace kept as backup. Set the change-over point with the owner.
- Materials / products used
- Cold-climate heat pump, new coil, dual-fuel control kit.
- Size
- One dual-fuel system for a home of about 2,200 sq ft.
- Final price
- $11,900.
- Cost per sq ft
- Not applicable — HVAC work is priced per job or per system, not per sq ft.
- Turnaround / duration
- 2 days on site.
- Payment terms / financing
- Half at booking, half at the walkthrough. Rebate lines shown apart in the quote.
- Problem found
- Aging AC plus a wish to cut gas use without losing cold-night heat.
- Solution delivered
- Heat pump heats and cools. The furnace takes over only on the coldest nights, by the setting the owner picked.
- Homeowner first name
- Ellen.
- Homeowner city / neighborhood
- Highlands Ranch — Northridge.
- Homeowner situation (in their own terms)
- I wanted off gas for most of the year but I did not trust a pump alone at ten below. The dual-fuel plan was the honest middle.
- Outcome and homeowner reaction
- The pump carried the house through the fall. Ellen said the open cost math 'was the first quote that showed me the weak points too.'
How heat pump work runs
- 1
Call and symptom check
10 minutes
For a repair: tell us when the pump loses ground — cold nights, defrost cycles, or all the time. For a new system: tell us your gas and power setup.
- 2
Site visit and test
About 1 hour
Repairs get a full test of charge, defrost board, and backup heat. New systems get a load check, a duct check, and a panel check, all in one visit.
- 3
Written price
Same visit
Repairs are priced per part. New systems are priced with the rebate lines shown apart, so you see the net cost, not a headline number.
- 4
The work
Half a day to 2 days
A repair is done the same visit in most cases. An install takes one to two days. Dual-fuel jobs set the change-over point with you before we leave.
- 5
Season check and sign-off
20 minutes
The pump runs in both modes. Backup heat is tested, not assumed. You get the settings in writing, and the bill matches the quote.
The honest math
At current Xcel gas and power rates, a heat pump can cost a bit more per month to heat with than a new high-efficiency gas furnace. The case for a pump rests on rebates, one system doing both jobs, and no combustion in the home. We show that math in the open, weak points and all.
Dual fuel: the middle path
A dual-fuel plan pairs the pump with a gas furnace. The pump heats for most of the year. The furnace takes over on the coldest nights, at a change-over point you pick with the tech. You get the rebate and the one-system ease, with gas heat held in reserve.
Signs you may need this page
- Your pump loses ground on cold nights or ices up and stays iced
- Defrost cycles run long, or backup heat runs far too often
- You want one system for heat and cool at a swap
- Your home has good insulation and ducts in conditioned space
- You pair rooftop solar and want heat on your own power
Book Step One: The Site Visit
Call 983-900-5808 or send the form. Pick your window in the form. The office calls the day before your visit to confirm.
Each job is logged step by step, from first call to final walkthrough. You get the written price before work starts.
Book a Site Visit
Pick your window here, or use the picker on the home page and it lands here for you. The office calls the day before to confirm.
Related services: Ductless Mini-Split Installation, HVAC Maintenance and Tune-Ups, and Emergency HVAC Repair.
Also serving: HVAC Services in Littleton, HVAC Services in Centennial, and HVAC Services in Castle Rock.
Related Services
AC Installation · AC Repair · Ductless Mini-Split Installation · Emergency HVAC Repair · Furnace Installation · Furnace Repair · HVAC Maintenance and Tune-Ups · HVAC Replacement · Thermostat Installation & Replacement · Indoor Air Quality Services · Air Duct Cleaning · Air Duct Repair & Replacement · Whole-Home Humidifiers · Ductless Mini-Split Repair